2008 Ford Ranger - Wheel Almost Fell Off! Broken Spindle! Replaced With Junkyard Parts - DIY!

Details

Description

https://amzn.to/3Fc59yU - Milwaukee 2767-20 M18 FUEL High Torque 1/2" Impact Wrench with Friction Ring
https://amzn.to/3RRWCJ7 - Milwaukee 2780-20 M18 Fuel 4-1/2"/5" Pad, Bare
https://amzn.to/3ROzmLZ - Orion Motor Tech Bearing Press Kit, 10pc Bearing Race and Seal Driver Set with Seal Driver and 9 Bearing Adapters, Seal Installer Bearing Driver Kit for Bearing Installation
https://amzn.to/3rPD6SP - 01-10 FORD RANGER 2WD 4" LIFT SPINDLES

Just a quick video showing how I changed a broken spindle on a 2008 Ford Ranger. I couldn't find the exact same replacement lift spindles locally and even after I realized that these steering knuckle / spindles were serviceable, I still couldn't find just the spindle replacements. I just found a lifted Ranger at a Junkyard and it happened to have the same height kit, even though it was a different brand of lift spindles.
I did end up replacing the other side as well so they would match. It's a good thing that I did, because the lower ball joint nut was just as loose as the driver's side and the outside bearing was also showing signs of heat and premature wear. I think the spindle nut was overtightened which is what caused the outside bearing to heat up and eventually weld itself to the spindle before it broke.

Thanks for watching!
Please Subscribe!
-Dan the Fix it Man
www.danthefixitman.org
www.amazon.com/shop/danthefixitman

Song used in the video:
'Crops' by Telecasted

This video is intended for entertainment and informational purposes only. Any repairs you make are your responsibility. I am not liable for any damages to you or your vehicle or your property.

As an Amazon Associate I earn from qualifying purchases.